This tab contains general information about the partner.
You can change general information about the partner using the fields described below by pressing the 'Edit' button. When you are done editing, remember to press the 'Save' button at the bottom of the page. Click 'Cancel' to undo your changes.
A Link specific Id. The Partner key field is not editable as it is used internally by Link to uniquely identify the partner.
The name of the partner is displayed here.
The type of the partner can be changed here. In Link, there can be two different types of partners: internal andexternal. An internal partner is an endpoint (typically of an application) within your organization. External partners are your business partners that you are exchanging data with.
If you have any comments or notes about the partner, they can be written here.
Accept Error Messages
If you tick the "Accept Error Messages" checkbox your are enabling Link's error handling mechanism to route error notification messages to this partner in the event that the partner are either the sending or the receiving partner in the relevant distribution.
Note that Link will only send error messages to a partner if you have enabled Notify stakeholder, Notify sender, or Notify receiver in the relevant error handling setup.
Note. Sending error messages to a partner means that all registered contact persons (with configure e-mail addresses) will receive notification messages.
We recommend that you read more about Error Handling in Link if you have not already done so.
Content on this page:
Please note, these errors can depend on your browser setup.
If this problem persists, please contact our support.